 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
4-4.
TRANSMISSION (CONT)
k. Governor and Rear Cover Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
11
p. Internal snap
Install
Beveled side toward rear of
(cont)
ring (22)
transmission
q. New oil seal
Install
Coat outer edge with non-hard-
(21)
ening sealant. Place on
utput shaft oil seal in-
staller, spring-loaded side
away from installer. Drive
oil seal (21) into bore
until its rear surface is
1.03 to 1.07 inch below rear
face of cover (19)
r.
New dust shield
Install
Place onto dust shield in-
(20)
staller, concave side first.
Coat outer edge with non-
hardening sealant. Drive
dust shield (20) into bore
until it is flush with, to
0.040 inch below, rear face
of cover (19)
s.
New outer race
Install
If old outer race (29) was re-
(29)
moved. Install, inner lip
first, until front of outer
race (29) is 0.080 to 0.090
inch below front surface of
bore
12
Shaft (8)
a. New cup plug
Install
If old cup plug (18) was re-
(18)
moved. Place on end of main
and output shaft orifice
installer. Install into
shaft (8) as shown
4-130
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals