 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
4-4. TRANSMISSION (CONT)
g. Low Planetary, Low Clutch, and Adapter Housing Assemblies (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
DISASSEMBLY (cont)
8
b.
External snap
Remove
As shown, step 8a Remove
(cont)
ring (13)
clutch spring compressor
base and low and first
clutch spring compressor
c
Spring retainer
Remove
(12)
d
26 piston re-
Remove
lease springs
(14)
e
Low clutch
Remove
piston (15)
9
Low clutch
a
Lip type seal
Remove
Discard
piston (15)
ring (16)
b
Lip type seal
Remove
Discard
ring (17)
NOTE
Disassemble carrier assembly (3) only if inspection shows replacement of parts is necessary.
10
Carrier
a.
Bushing (20)
Remove
Press out
and bushing
b.
Six pins (21)
Remove. Use drill press and drill bit slight-
assembly
ly smaller than diameter of pins (21).
(19)
Drill into rear ends of pins (21). Do not
drill into carrier and bushing assembly
(19). Place removing, installing and swag-
ing fixture on arbor press. Place carrier
and bushing assembly (19) on fixture,
drilled ends of pins (21) up. Install pin
remover into fixture. Press pins (21) from
carrier and bushing assembly (19). Remove
carrier and bushing assembly (19) from
arbor press
4-81
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals