 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
4-4. TRANSMISSION (CONT)
b. Main Shaft and Gear Unit Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
16
against carrier (42), as shown. Pinion set
(cont)
(28) must rotate freely and have 0.008-
0.031 inch end play. Remove carrier from
fixture
17
Shaft (4)
New lube orifice
Install
If old lube orifice plug (22)
plug (22)
was removed. Use main and
output shaft orifice in-
staller. Install small-ori-
ficed end first. Press in
until front of plug is re-
cessed 0.140-0.180 inch be-
low front end of shaft (4)
18
Center sun
Two new spring
Install
If old spring pins (9) were
gear shaft
pins (9)
removed. Split in pin must
assembly
be toward an adjacent spline
(8)
tooth. Press in until outer
end of pin (9) is flush
with, to 0.010 inch below,
top of spline teeth
4-36
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals