 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
3-42. FIFTH WHEEL HYDRAULIC SYSTEM MAINTENANCE (CONT)
d. Hydraulic Cylinders (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
CAUTION
Take care not to damage rings (19 and 20) or solid seal (15) when performing following step.
13
Cylinder
a.
Cylinder (8)
Lubricate
Lightly coat inside diameter
(8)
with clean hydraulic oil
b.
Rod (12) with
Install
As an assembly. Compress
piston (14)
solid seal (15) while slid-
and gland
ing piston (14) into
(11)
cylinder, and compress
rings (19 and 20) while
sliding gland (11) into
cylinder
c.
Gland (11)
Position
Rotate until hole in gland
(11) is visible in slot in
cylinder (8) barrel
d.
Retaining ring
Position
Engage retaining ring (10) in
(10)
hole in gland (11)
e.
Gland (11)
Rotate
Rotate gland (11) until
retaining ring (10) is
completely drawn into
cylinder (8)
f.
Identification
Position and
Use new drive screws (21), if
plate (22)
install
removed
g.
Two lubrication
Install
Straight fitting (24) in rod
fittings
cap (3); 90 degree fitting
(23 and 24)
(23) in cylinder (8)
NOTE
Repeat steps 11 thru 13 above to reassemble remaining hydraulic cylinder.
INSTALLATION
NOTE
Perform steps 14 and 15 below only if shaft (27) and spacer tube (28) were removed; otherwise, proceed to step 16.
3-449
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals