 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
3-35.
BODY AND CAB MAINTENANCE (CONT)
i. Seat (cont).
(1) Upper Seat Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
12
Cushion
assemblies
(11 and 15)
NOTE
Heat seat cover (49) with steam, hot air or infrared lamps prior to and during installation. If these
heat sources are not available, place cover in direct sunlight approximately 15 minutes before
installation.
a
Cover (49)
Heat
b
Cover and pad
a Glue
Glue cover and pad to seat
(49)
cushion pan (48)
b Roll over
Roll cover over edge of pad
c Fasten
Fasten to edge of seat
cushion pan (48) by insert-
ing plastic welt into clips
where provided
c
Seat cushion
Install
assembly (11)
d
Latch bar (36)
Engage
In slots in latch and handle
assembly (33)
e
Latch assembly
Install
(8)
f
Seat cushion
Push down
assembly (11)
g
Pivot shaft (10) Install
h
Two new snap
Install
Use retaining ring pliers
rings (9)
13
Latch
a
Latch bar (36)
Press down
Insert screwdriver in slot at
assembly
front of plate and latch
(8)
assembly (41) Press down
on latch bar (36); then tap
latch bar until it engages
in slots in latch and';
handle assembly (33).
Continue pressing down on
latch bar until roll pin
(37) engages hole in plate
and latch assembly (41)
3-380
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals