INSPECTION (cont) - TM-9-2320-285-24-20296

TM 9-2320-285-24-2

3-28.

STEERING SYSTEM MAINTENANCE (CONT)

f. Power Steering Pump (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

INSPECTION (cont)

h. Bearing (33)

Inspect

Inspect all rollers, cages (cont) and

cups for wear, chips, nicks, cracks,

damage, and distortion. If any of

these conditions are observed,

replace bearing. After inspection,

immerse in clean light oil and wrap

in clean lintless cloth or paper

WARNING

Compressed air must not exceed 30 psi. Wear safety glasses when drying parts with compressed air.

Failure to do so could cause serious injury to-eyes and possible blindness. If you hurt your eyes or if a

foreign object is blown into your eyes, seek medical attention immediately.

i. Body (34)

Inspect

Replace

cracked,

broken,

distorted, or threads damaged.

Clean bores with compressed air

j. Control valve

Inspect

Replace if cracked, broken, (38) or

distorted.

Check for freedom of

movement in bore of cover (18)

REASSEMBLY

NOTE

Immerse all internal parts in clean hydraulic oil before reassembly.

Shake off excess oil during

reassembly, but don't wipe.

Cover (18)

Clamp

In soft jawed vise

Spring (39),

Install

In cover (18)

control valve

(38), new

O-ring (37),

and plug (36)

Pin (35)

Install

Use pin punch and hammer

Cover (18)

Remove

From vise

3-290