|
|
TM 9-2320-285-24-2
3-28.
STEERING SYSTEM MAINTENANCE (CONT)
f. Power Steering Pump (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
CLEANING (cont)
WARNING
Compressed air must not exceed 30 psi. Wear safety glasses when drying parts with compressed air. Failure to do
so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into
your eyes, seek medical attention immediately.
5
a
Bearing (33)
Clean
Use cleaning solvent P-D-680.
Immerse bearing in cleaning
solvent and move slowly up
and down. Remove bearing.
Strike larger side of cone
against block of wood to
dislodge solidified
particles of lubricant.
Immerse again in cleaning
solvent. Repeat process
until bearing is thoroughly
clean. Dry using moisture
free compressed air. Direct
air stream across bearing.
Do not spin bearings when
drying. Rotate bearings
slowly by hand to
facilitate drying
b
All other parts
Clean
Use cleaning solvent P-D-680;
dry with compressed air
INSPECTION
6
a
Adapter (6) and
Inspect
Replace if cracked, broken,
plate (10)
or distorted
b
Gear (11) and
Inspect
Replace if cracked, broken,
coupling (12)
distorted or teeth pitted,
nicked, scored, or badly
worn
3-288
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |