|
|
TM 9-2320-285-24-2
3-28.
STEERING SYSTEM MAINTENANCE (CONT)
f. Power Steering Pump (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
DISASSEMBLY
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and
use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe vapors. Do not use
near open flame or excessive heat and don't smoke when using it. Failure to do so could cause serious injury. If
you become dizzy while using cleaning solvent, get fresh air and medical attention immediately. If contact with skin
or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water and obtain
medical aid immediately.
Compressed air must not exceed 30 psi. Wear safety glasses when drying parts with compressed air. Failure to do
so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into
your eyes, seek medical attention immediately.
2
Power
a
Pump exterior
Clean
Wash exterior using cleaning
steering
solvent P-D-680; dry with
pump
compressed air
assembly
b
Screw (13) and
Remove
Discard washer (14)
(3)
washer (14)
c
Manifold (15)
Remove
Discard gasket (16)
and gasket
(16)
d
Power steering
Clamp
In soft jawed vise with vise
pump assembly
jaws contacting body (34)
(3)
and capscrews (17) facing
up
e
Four capscrews
Remove
(17)
f
Cover (18) and
Remove
spring (19)
g
Ring (21)
Hold securely
h
Pressure plate
Remove
Lift up over pins (22)
(20)
i
Ring (21)
Remove
Lift up over pins (22)
j.
'Two pins (22)
Remove
k
Rotor (23)
Remove
Lift over shaft (28); vanes
(24) will fall out
3-286
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |