DISASSEMBLY (cont) - TM-9-2320-285-24-20270

TM 9-2320-285-24-2

3-28.

STEERING SYSTEM MAINTENANCE (CONT)

d. Power Steering Gear (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

DISASSEMBLY (cont)

Ball nut (38)

Remove

Press small end of mandrel against hole

(cont)

in end of top cover assembly (1)

worm shaft.

Maintain pressure

against mandrel while rotating ball

nut (38) clockwise to remove from

worm shaft. When ball nut is fully

seated on mandrel, remove mandrel

with ball nut and set aside with large

end of mandrel positioned on work

surface.

Seal ring (52)

Remove and

discard

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well

ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe vapors.

Do not use near open flame or excessive heat and don't smoke when using it. Failure to do so could cause serious injury. If you

become dizzy while using cleaning solvent, get fresh air and medical attention immediately. If contact with skin or clothes is made,

flush with large amounts of water. If contact with eyes is made, wash eyes with water and obtain medical aid immediately.

Compressed air must not exceed 30 psi. Wear safety glasses when drying parts with compressed air. Failure to do so could cause

serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into your eyes, seek medical

attention immediately.

3-264