 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
3-10. STARTER MAINTENANCE (CONT)
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
17
d.
Drive assembly
Check clearance
Push clutch back as far as
(cont)
(58) pinion
possible toward armature;
check clearance as shown
NOTE
Pinion clearance must measure 0.359 inch to prevent buttons on lever (48) from rubbing on the clutch collar during
cranking. If clearance is not correct, nut (33) can be adjusted. If proper clearance can't be achieved, recheck for
proper assembly, and replace all worn parts.
e.
Starter with
Disconnect
From pinion clearance test
switch
set-up
f.
Connector (63)
a.
Remove
tape
b.
Install
On motor (M) terminal
of switch (35)
g.
Nut (53)
Install
Tighten to 20-25 pounds foot
3-60
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals