|
|
TM 9-2320-285-24-1
2-85.
SPEEDOMETER MAINTENANCE (CONT)
STEP
LOCATION
ITEM
ACTION
REMARKS
INSPECTION
8
a.
Cable housing
Inspect
Replace if nuts cracked,
(2) with nuts
broken, or threads
damaged;
(1 and 7)
or if cable housing broken,
cracked, or deteriorated
b. Speedometer
Inspect
Replace if cracked, broken,
head (6)
pointer broken or bent,
or
mechanism binding or frozen
c.
Speedometer
Inspect
Place cable on flat surface,
cable (12)
then twist one end with
fingers. A good cable will
turn over smoothly over
entire length. Kinked cable
will flop over after
initial twisting motion.
Replace if kinked or other-
wise damaged
d. Adapter (8) and
Inspect
Turn shaft to check for free-
gear assembly
dom of movement. Replace
if
(9)
cracked, broken, threads
damaged, binding or frozen,
or teeth broken or missing
e. All other parts
Inspect
Replace if cracked, broken,
distorted, or threads
damaged
INSTALLATION
9
Left hand
a. Cable housing
Route
b. Seven new tie
Install
At locations noted during
straps (11)
removal
10
Cab floor
Cable housing (2)
Install
Through cab floor into cab
and grommet (10)
11
Transmis-
a. Gear assembly
Install
Make certain that gear teeth
sion rear,(9)
mesh properly with
left side
speedometer gear on
transmission
b. Adapter (8)
Install
c. Cable housing
Connect
To adapter (8)
(2)
d. Cable nut (7)
Tighten
12
Cab tilt
Cab
Lower To normal operating
position
pump
2-914
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |