|
|
TM 9-2320-285-24-1
2-73. HEATERS MAINTENANCE (CONT)
f.
Junction Box.
This task covers:
a. Removal
c. Inspection
b. Cleaning
d. Installation
e. Testing
INITIAL SETUP:
Tools
Personnel Required
No. 1 Common Organizational Maintenance
Wheel Vehicle Mechanic MOS 63B
Tool Kit
Adjustable open end wrench
Equipment Condition
Socket wrench set
Paragraph
Condition Description
Screwdriver
Screwdriver set
Parked on level surface;
Safety glasses
engine off, and parking brake
applied.
Materials/Parts
Winterization system cable
Cleaning solvent
Item 1, Appendix C
disconnected from junction box.
Clean cloths
Item 2, Appendix C
Tags
Item 14, Appendix C
Electrical tape
Item 37, Appendix C
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
WARNING
The winterization heaters operate from a 110 Vac commercial power
source. Disconnect winterization system cable from receptacle at front
bumper of tractor before proceeding. Serious injury or death can result
from contact with energized 110 Vac power lines.
NOTE
Perform steps la and lb below if necessary to remove door. If door is
removed, proceed directly to step 1c below.
1
Inside
a. Latch (15)
Rotate
90 degrees
front
b. Door (1)
Remove
Slide down
bumper,
c. Nut (2) and
Remove
From bumper
right side
clamp (3)
d. Electrical
Remove
Note locations for instal-
tape
lation
e. Plastic tubing
Remove
Pull open at slit and remove
(4)
from cord sets
2-850
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |