|
|
TM 9-2320-285-24-1
2-73.
HEATERS MAINTENANCE (CONT)
e.
Coolant Heater and Pump (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (cont)
12
f. 3-wire cord
Position
On heater element (58) as
(cont)
(55) wire
tagged (green ground wire
ends
at center terminal)
g. Three screws
Install and
Secures wire ends
(54)
tighten
h. Cover (56)
Position
Align holes in cover (56)
with holes in heater
element (58)
i. Two screws (53)
Install and
Secures cover (56)
tighten
j. Strain relief
Install
Position around jacket of 3-
(57)
wire cord (55) near cover
(56); then squeeze with
pliers and push into cover
k. Hose (52)
Position
l. Clamp (51)
Install and
tighten
m. Clamp (50)
Install
Do not tighten
13
Thermostat
a. Sensor (49)
Position
In base (68)
(36)
b. Two setscrews
Install and
Secures sensor (49)
(48)
tighten
c. Base (68)
Install
On hose (52)
d. Clamp (50)
Tighten
WARNING
Be sure you twist together the same color wire ends in the following step.
Connect green-to-green, white (or gray)-to-white, and black (or remaining
color)-to-black. Incorrect connections or exposed conductors can cause
the engine and body of the tractor to be energized at 110 Vac. Serious
injury or death can result from contact with 110 Vac power.
e. Cover (43)
Position
Slide onto 3-wire cords
(6 and 45) until terminals
are exposed
f. 3-wire cords
Connect
As tagged (plug one terminal
(6 and 45)
end of each cord into
thermostat sensor (49);
connect green wire
terminals; twist remaining
wire ends together)
2-845
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |