 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-1
2-73.
HEATERS MAINTENANCE (CONT)
c.
Battery Warmers (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSPECTION (CONT)
5
c. Wire nuts (4)
Inspect
Replace if cracked or broken
(cont)
d. Wire ties (8)
Inspect
Replace if broken
e. Battery warmers
Inspect
Replace if 3-wire cord jacket
(9) with
or insulation cracked, cut,
3-wire cords
or frayed, if conductors
(6 and 7)
corroded or broken, or if
battery warmer defective
INSTALLATION
6
Tractor
a. 3-wire cord (5)
a. Install
Para 2-73f, if removed
right hand
and plastic
b. Route
From front spring shackle
frame and
tubing (2)
top joint to battery box
bumper
b. Six new tie
Install
In locations noted during
straps (10)
removal
c. New electrical
Install
Wrap around plastic tubing
tape
(2) in locations noted
during removal
CAUTION
Do not overlap battery warmers in following step to prevent overheating.
7
Battery
a. Two battery
Position
Wrap around batteries with
box
warmers (9)
"THIS SIDE IN" marking
with 3-wire
against batteries and "TOP"
cords
marking at top. Pull
(6 and 7)
tightly at corners
b. Two wire ties
Install and
(8)
secure
c. 3-wire cords
a. Cut and
If necessary, cut cord to
(6 and 7)
prepare
length shown. Discard cut
end with plug; then
separate wire ends and
strip 1/4 inch insulation
from each wire
b. Route
Push through grommets in
bottom of battery box
8
Right hand
a. Plastic tubing
Install
Pull open at slit and install
frame rail,
(3)
around 3-wire cord (6)
behind
battery box
2-828
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals