|
|
TM 9-2320-285-24-1
2-65. BODY AND CAB MAINTENANCE (CONT)
1. Seat Belt and Seat (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSPECTION AND REPAIR (cont)
4
c. Seat assembly
Inspect for:
Repair small tears or rips
(cont)
(13)
rips
using needle and thread;
worn areas
replace if uneconomical to
deteriora-
repair (notify direct
tion at
support maintenance). Refer
seat and
to TM 9-2320-285-10 for
back
seat adjustments to check
proper
for proper operation
operation
d. All other parts
Inspect for:
Replace if defects are
damaged
observed
threads
distortion
deformation
INSTALLATION/ REPLACEMENT
5
Cab
Seat assembly (13)
Position
Align mounting holes in seat
interior
assembly (13) with mounting
holes in cab floor
6
Cab floor,
a. Four washers
Install
Secures seat assembly (13)
near seat,
(12), cap-
to cab floor
left and
screws (11),
right sides
washers (10),
and locknuts
(9)
b. Tether (8)
Position
On cab floor; align mounting
floor bracket
holes
c. Two capscrews
Install
Do not tighten
(7), rein-
forcing plates
(6), lock
washers (5),
and nuts (4)
NOTE
Adjust tethers (8) adjusters to obtain more slack in tethers (8) as necessary when performing the following
step.
2-751
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |