REASSEMBLY/INSTALLATION (cont) - TM-9-2320-285-24-10567

TM 9-2320-285-24-1

2-50.

SERVICE BRAKE SYSTEM MAINTENANCE (CONT)

Front Axle Brakes (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

REASSEMBLY/INSTALLATION (cont)

b. Install

Push seals (10) onto plungers

(cont)

(9), stretching outer seal

lip over taped end of

plunger, until inner lip is

seated in second plunger

groove and outer lip is

seated in first plunger

groove. Remove masking

tape

j. Two plungers

Lubricate

Coat plungers (9) and plunger

(9)

housing bores with grease;

fill cavities behind seals

seals (10) with grease

NOTE

Install plungers (9) marked "L" in left hand brake, and plungers marked "R" in right hand

brake. The solid plungers (9) must be installed in the plunger housing locations at the trailing

end of each brake shoe (2) as shown below.

k. Two plungers

Install

Into bores of spider (25),

(9)

with keyways in plungers

aligned with holes in guide

screws (3). Be sure plung-

ers go all the way into

bores, and sit on bosses at

bottom of bores

2-544