|
|
TM 9-2320-285-24-1
2-41. TRANSMISSION MAINTENANCE (CONT)
h.
Shift Lockout Cylinder, Lines, and Fittings (cont).
(2) Shift Lockout Cylinder and Linkage (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
CLEANING (cont)
WARNING
Compressed air must not exceed 30 psi. Wear safety glasses when
drying parts with compressed air. Failure to do so could cause serious
injury to eyes and possible blindness. If you hurt your eyes or if a foreign
object is blown into your eyes, seek medical attention immediately.
3
Exterior of air
Clean
Use cleaning solvent P-D-680;
cylinder (3) and
dry using compressed air
all other parts
INSPECTION
4
a. Air cylinder
Inspect
Replace if cylinder or end
(3)
caps cracked or dented, rod
bent, threads damaged, or
air cylinder inoperative
b. Bushings (15
Inspect
Replace if cracked, worn, or
and 21)
holes elongated
c. All other parts
Inspect
Replace if cracked, corroded,
distorted, bent, or threads
damaged
REASSEMBLY
5
Air
a. Nut (17)
Install
To approximately 2/3 of rod
cylinder
thread
(3)
b. Cylinder rod
Install
To approximately 1/2 of rod
block (16)
thread
c. Nut (17)
Tighten
d. Three bushings
Install, if
In lever (20)
(21)
removed
e. Lever (20)
Position
On rod blocks (16 and 19) and
air cylinder (3) pin
f.
Three retaining
Install
rings (18)
g. Three bushings
Install, if
In lever (14)
(15)
removed
h. Lever (14)
Position
2-480
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |