 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-1
2-41. TRANSMISSION MAINTENANCE (CONT)
h.
Shift Lockout Cylinder, Lines, and Fittings (cont).
(1) Shift Lockout Lines and Fittings (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REPAIR (cont)
10
Tubing
a. Tubing (2, 6,
Cut Between nut and sleeve
(2, 6,
or 9)
or 9)
b. Nut Remove
Slide from tubing
c. Insert
Remove, if
Pull from tubing only if
necessary
separated from fitting (1,
3, 5, or 8)
d. Sleeve
Discard
NOTE
Repeat steps 10a thru 10d above to disassemble remaining connectors
from tubing (2, 6, or 9).
e. Tubing (2, 6,
Cut to proper
Use new tubing; use old
or 9)
length
tubing to determine proper
length
f.
Nut Position
Slide onto tubing; threaded
end out
g. New sleeve
Position
Slide onto tubing
h. Insert
Install, if
Push into tubing only if
necessary
separated from fitting
WARNING
Tubing must be installed over insert for secure connection. Installation of
connector without insert will allow air pressure to force tubing from fitting,
resulting in dangerous loss of air pressure.
2-473
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals