REMOVAL - TM-9-2320-285-24-10474

TM 9-2320-285-24-1

2-41. TRANSMISSION MAINTENANCE (CONT)

Vent Assembly (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

REMOVAL

Top front

a. Vent assembly

Remove and

Pry from vent assembly stem

of trans-

(1) cap

discard

mission (2)

b. Vent assembly

Remove and

Be sure area around stem is

(1) stem

discard

clean; remove using vise

grip pliers

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective

goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and

clothes and don't breathe vapors. Do not use near open flame or excessive heat and don't

smoke when using it. Failure to do so could cause serious injury. If you become dizzy while

using cleaning solvent, get fresh air and medical attention immediately. If contact with skin or

clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes

with water and seek medical aid immediately.

CLEANING

Vent assembly (1)

Clean

Use cleaning solvent P-D-680.

Move up and down in solvent

to remove all dirt. Dry

with soft, clean, lintless

cloth

INSPECTION

Vent assembly (1)

Inspect

Inspect for damaged threads

and blocked passages.

Replace if defective

INSTALLATION

Top front

New vent assembly

Install

Coat threads with clean

of trans-

(1)

transmission fluid. Tighten

mission (2)

vent assembly (1) stem

using needle nose pliers

2-451