REPAIR - TM-9-2320-285-24-10469

TM 9-2320-285-24-1

2-41. TRANSMISSION MAINTENANCE (CONT)

e. External Oil Filter (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

REPAIR

CAUTION

If fittings (2, 4, 17, 19, 25 and/or 34) require replacement, discard hose (3, 5, or 20). If hose

is reused, oil leakage could occur causing damage to transmission.

Hose (3,

a. Fitting

Place fitting socket in vise as shown

5, or 20)

b. Mandrel assem-

Install in fitting nipple; tighten nut of

bly tool

fitting. Turn tool counterclockwise to

remove fitting nipple and nut

c. Hose

Turn hose clockwise out of fitting socket;

discard hose

NOTE

Repeat step 9 above to remove remaining fittings from hose(s).

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and

gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe

vapors. Do not use near open flame or excessive heat and don't smoke when using it. Failure to do so

could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air and medical

attention immediately. If contact with skin or clothes is made, flush with large amounts of water. If contact

with eyes is made, wash eyes with water and seek medical aid immediately.

Fittings

Clean

Use cleaning solvent P-D-680;

allow to air dry. Use wire

brush to remove all hose

residue from socket and/or

nipple of fittings

Hose

a. Hose

Cut to proper

Use new hose; use old hose

length

for determining length

required. Cut hose square

using fine tooth hacksaw

b. Fitting

Place fitting socket in vise as shown

2-446