Front Panel Harness (cont)

TM 9-2320-285-24-1

2-35.

WIRING HARNESS MAINTENANCE (CONT)

Instrument Panel Harnesses (cont).

(1)

Front Panel Harness (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

CLEANING

a. Front panel

Clean

Wipe with a clean, dry cloth

harness (5)

where wiring is accessible

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective

goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and

clothes and don't breathe vapors. Do not use near open flame or excessive heat and don't

smoke when using it. Failure to do so could cause serious injury. If you become dizzy while

using cleaning solvent, get fresh air and medical attention immediately. If contact with skin or

clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes

with water and seek medical aid immediately.

b. Connectors

Clean

Use cloth moistened with

(1 thru 4)

cleaning solvent P-D-680;

dry with clean cloths

INSPECTION/REPAIR

a. Connectors

Tag and

(1, 2, and 3)

disconnect

b. Two capscrews

Remove

Note location of electrical

(6) and elec-

lead (7)

trical lead

(7)

c. Fuse block and

Remove

From cab firewall

bulkhead con-

nector (4)

d. Trailer hand

Disconnect

Para 2-32f(2)

brake stop

wires

light switch

e. Connectors

Inspect

Replace front panel harness

(1 thru 4)

(5) if connector bent or

damaged (notify direct

support maintenance)

NOTE

Gage of replacement wire must be greater than or equal to gage of defective wire.

2-401