|
|
TM 9-2320-285-24-1
2-13.
FUEL SYSTEM MAINTENANCE (CONT)
e. Accelerator and Throttle Linkage (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (cont)
17
c. Ball joint (6)
Install
On accelerator cable (11);
(cont)
screw all the way on then
back-off one turn or until
stud is in correct position
to install in lever (33)
d. Ball joint (6)
Connect
To lever (33)
stud
e. Lock washer (5)
Install and
and nut (4)
tighten
18
Modulator
a. Nut (23)
Install
Almost to end of threads on
cable
modulator cable assembly
assembly
(25)
(25)
b. Spring (24) and
Position
On cable (25) shaft
bracket (7)
c. Nut (22)
Install and
Secures spring (24) and
tighten
bracket (7) to cable
(25)
19
Lever (33)
a. Bracket (7)
Position
b. Washer (21),
Install and
capscrew
tighten
(20), and
locknut (19)
NOTE
To complete installation of accelerator cable (11)install two new tie straps and secure accelerator cableto radiator brace.
ADJUSTMENTS
20
Engine
a. Ball joint (6)
Adjust
Check that ball joint engages
governor
cable (11) shaft a minimum
housing
of 1/4 inch. If not adjust
for minimum 1/4 inch
engagement
b. Throttle arm
Rotate
Clockwise to full open
(34)
position
2-113
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |