Quick Start

TM 9-2320-285-24-1

2-13.

FUEL SYSTEM MAINTENANCE (CONT)

d. Quick Start.

This task covers:

a. Removal/Disassembly

c. Inspection

b. Cleaning

d. Reassembly/Installation

INITIAL SETUP

Tools

Personnel Required

No. 1 Common Organizational Maintenance

Wheel Vehicle Mechanic MOS 63B

Tool Kit

Adjustable open end wrench

Equipment Condition

Socket wrench set

Paragraph Condition Description

Safety glasses

Tool kit, electrical connector

Parked on level surface;

Crimping tool

parking brake applied; engine

Wire stripper

off.

Cab tilted 45 degrees.

Materials/Parts

2-15a(l)

Coolant drained from radiator.

Cleaning solvent

Item 1, Appendix C

Clean cloths

Item 2, Appendix C

Ether cylinder

FSCM 61112 PN LP535

Crimp connector

FSCM 90915 PN 90828080

STEP

LOCATION

ITEM

ACTION

REMARKS

REMOVAL/DISASSEMBLY

WARNING

Cylinder (4) contains ether which is highly flammable and under pressure. Do not

puncture cylinder (4) or discard in an open fire. When performing the following

steps, do not smoke or allow open flames or sparks into the area. Death or

severe injury may result if personnel fail to observe this precaution. If you are

burned, obtain medical attention immediately.

Air clean-

a. Two wing nuts

Remove

er, left

(1), lock

side, rear

washers (2),

and bracket

(3)

b. Cylinder (4)

Unscrew and

From ether valve (22); then

remove

gently shake cylinder to

estimate quantity of ether

remaining. Empty cylinder

weight is approximately

17 ounces; full cylinder

weight is approximately 37

ounces

2-97