|
|
TM 9-2320-285-24-1
2-12. ENGINE MAINTENANCE (CONT)
d. External Oil Filter and Lines (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REPAIR (cont)
21
Hose (31)
a. Hose (31)
Cut to proper
Use new hose; use old hose
length
for determining length
required. Cut hose square
using fine tooth hacksaw
b. Connector (29
Place connector socket in vise as shown
or 30)
c. Hose (31)
Screw hose counterclockwise into socket
until hose bottoms; back hose off 1/4 to
1/2 turn
d. Mandrel assem-
Oil nipple threads, mandrel assembly tool,
bly tool
and inside of hose liberally using hydrau-
lic oil. Tighten connector nipple and nut
on mandrel assembly tool. Apply oil to all
parts
e. Connector (29
Screw nipple clockwise into socket and hose.
or 30)
Allow 1/32 to 1/16 inch clearance between
nut and socket so nut will swivel. Remove
mandrel assembly tool from connector.
Remove connector from vise
NOTE
Repeat steps 21b thru 21e above to install remaining connector on hose
(31).
22
Hose (34)
a. Hose (34)
Cut to proper
Use new hose; use old hose
length
for determining length
required. Cut hose square
using fine tooth hacksaw
b. Connector (32)
Install
Perform steps 21b thru 21e
above
c. Elbow (33)
Place elbow socket in vise
d. Hose (34)
Screw hose (34) counterclockwise into socket
until hose bottoms; back off hose 1/4 to
1/2 turn
2-53
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |