|
|
TM9-2320-270-20-3
HYDRAULIC RESERVOIR - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
REMOVAL - CONTINUED
a. Using 15/16-inch socket and handle
Screw (3) and seal
27. Reservoir (1) and
with 1/2-inch drive, unscrew and take
washer (4)
cover (2)
off.
b. Get rid of seal washer (4).
a. Take off.
Cover (2) and
28. Reservoir (1)
b. Get rid of gasket (5).
gasket (5)
INSTALLATION
Put in place.
New gasket (5)
29.
Put in place.
Cover (2)
30.
Screw in and tighten using 15/16-inch
New seal washer (4)
31. Reservoir (1)
socket and handle with 1/2-inch drive.
and screw (3)
and cover (2)
WARNING
Some parts are heavy. Be careful when handling them. Lifting equipment is needed
when parts weigh over 50 pounds (23 kg) for a single person lift, over 100 pounds
(45 kg) for a two person lift, and over 150 pounds (68 kg) for a three or more person
lift. Do not try to handle heavy parts without lifting equipment. Keep clear of heavy parts
supported only by lifting equipment. Failure to observe this precaution could cause
serious injury or death of personnel.
a. Put spacers (7) in place.
Three spacers (7)
32. Deck (6)
b. Attach lifting equipment.
and reservoir (1)
c. Using lifting equipment, place in
position.
Screw in and tighten using 15/16-inch
Two screws (8)
33. Reservoir (1)
wrench.
Screw on and tighten using two 15/16-inch
Screw (9), spring
34.
wrenches.
(10) and nut (11)
Using pliers, put on.
New cotter pin (12)
35.
a. Put filter base (13) in vise.
Pipe (14)
38. Filter base (13)
b. Screw in and tighten using pipe wrench.
c. Take filter base (13) out of vise.
Put in place.
New packing (15)
37.
4-1168
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |