 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-270-20-3
RADIATOR AND HEADLIGHT GUARD- CONTINUED
--
ACTION
REMARKS
ITEM
LOCATION
REMOVAL- CONTINUED
Using 3/4-inch socket, ratchet handle with
Four screws (3),
Radiator and
5.
1/2-inch drive, and 3/4-inch wrench, un-
eight washers (4),
headlight guard (1)
screw and take out.
and two nuts (5)
to two support
braces (2)
Using 15/16-inch socket, ratchet handle
Two screws (7),
Radiator and
6.
four washers (8),
with 1/2-inch drive, and 15/16-inch
headlight guard (1)
wrench, unscrew and take out.
and two nuts (9)
to bumper(6)
WARNING
Some parts are heavy. Be careful when handling them. Lifting equipment is needed
when parts weigh over 50 pounds (23 kg) for a single person lift, over 100 pounds
(45 kg) for a two person lift, and over 150 pounds (68 kg) for a three or more person
lift. Do not try to handle heavy parts without lifting equipment. Keep clear of heavy parts
supported only by lifting equipment. Failure to observe this precaution could cause
serious injury or death of personnel.
Take off.
Radiator and head-
Bumper (6)
7.
light guard (1)
CLEANING
All parts
Clean according to general maintenance
8.
instructions (page 4-1).
lNSPECTION/REPLACEMENT
Inspect according to general maintenance
All parts
9.
instructions (page
INSTALLATION
WARNING
Some parts are heavy. Be careful when handling them. Lifting equipment is needed
when parts weigh over 50 pounds (23 kg) for a single person lift, over 100 pounds
(45 kg) for a two person lift, and over 150 pounds (68 kg) for a three or more person
lift. Do not try to handle heavy parts without lifting equipment. Keep clear of heavy parts
supported only by lifting equipment. Failure to observe this precaution could cause
serious injury or death of personnel.
Place in position.
Radiator and head-
10. Bumper (6)
light guard (1)
4-1090
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals