 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9-2320-270-20-2
PUSHER AXLE HUB, DRUM, AND BEARING ASSEMBLY - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
INSTALLATION - CONTINUED
WARNING
Make sure no grease remains on brakedrum and that no grease contacts brake linings.
If linings become contaminated with grease, brakes on that wheel will fail and could
cause serious accident. Contaminated linings cannot be cleaned and must be replaced.
a. Wipe bearing cone (2) and bearing cup
Outer bearing
45. Hub (1)
(3) with gear lubricant oil.
cone (2)
b. Put in.
Adjusting nut (5)
a. Screw onto spindle until hub (1) can
46. Spindle (4)
turn.
b. Lower lift truck.
Rotate.
Hub (1) and
47.
drum (6)
a. Using 3/4-inch drive torque wrench and
Adjusting nut (5)
48.
4 1/4-inch socket, tighten to 50 foot
pounds (67.8 Nm).
b. Using 4 1/4-inch socket and 3/4-inch
drive handle, back off nut just enough
to eliminate binding.
Put on making sure pin (8) on adjusting
New lockwasher (7)
49. Spindle (4)
nut (5) goes through one of the holes (9)
in the lockwasher (7).
If it does not, use 4 1/4-inch socket
and 3/4-inch drive handle to tighten
adjusting nut (5) just enough to get
pin (8) in hole (9).
a. Screw on using 4 1/4-inch socket and
Locknut (10)
50.
3/4-inch drive handle.
b. Using 3/4-inch torque wrench and
4 l/4-inch socket, tighten to 250 to
400 foot pounds (339 to 542 Nm).
4-922
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals