 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-270-20-2
RETARDER CONTROL LINKAGE - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
ADJUSTMENT CONTINUED
a. Depress as far as possible.
Control pedal (3)
75. Mounting bracket (1)
Pedal should just touch stop screw
and stop screw (2)
as retarder control valve reaches
end of travel.
b. Release.
c. Repeat steps 72 thru 75 until stop
screw adjustment is correct.
a. Pull down on joint socket.
Detachable ball-
76. Control pedal (3)
b. Pull joint socket off of joint ball.
joint (5)
and pedal rod (4)
Pull back.
Control pedal (3)
77. Mounting bracket (1)
with assembled parts
Pull up.
a.
Floormat (8)
78. Cab floor (6),
Move back.
b.
stop screw (2), and
dimmer switch (7)
a.
Using 3/8-inch open-end wrench, hold
Nut (9)
79. Stop screw (2) and
stop screw (2) from turning.
cab floor (6)
Using 1/2-inch open-end wrench, turn
b.
nut (9) one more full turn.
This will prevent strain on retarder
control valve.
a.
Using 3/8-inch open-end wrench, hold
Stop screw (2) and
80. Cab floor (6)
stop screw (2) from turning.
nut (10)
Using 1/2-inch open-end wrench,
b.
through cab floor (6), tighten
nut (10).
Put in place.
a.
Floormat (8)
81. Cab floor (6),
Push down over screw (2) and
b.
stop screw (2), and
switch (7).
dimmer switch (7)
Move forward to operating position.
Control pedal (3)
82. Mounting bracket (1)
a. Pull down on joint socket.
Detachable ball-
83. Control pedal (3)
b. Push joint socket onto joint ball.
joint (5)
and pedal rod (4)
4-560
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals