INSTALLATION CONTINUED - TM-9-2320-270-20-20036

TM 9-2320-270-20-2

RETARDER CONTROL LINKAGE - CONTINUED

ACTION

REMARKS

ITEM

LOCATION

INSTALLATION CONTINUED

Slide in position.

Two new cotter

41. Two clevis pins (1)

Using long roundnose pliers, bend

pins (2)

ends.

NOTE

Perform steps 42 thru 44 only if stop screw was found damaged, or needed to be

removed.

Screw on as far as possible.

Nut (4)

42. Stop screw (3)

Slide in position.

Stop screw (3) with

43. Cab floor (5)

assembled nut (4)

Nut (6)

Screw on about two full turns.

44. Stop screw (3) and

Stop screw and two nuts will be

cab floor (5)

tightened during adjustment.

NOTE

Perform steps 45 and 46 only if mounting bracket was removed.

Pedal pin mounting holes in mounting bracket are set off center. Position bracket so that

pedal pin mounting holes are toward front of vehicle.

Place in position.

Mounting bracket (7)

45. Cab floor (5)

Be sure pedal pin mounting holes

are closer toward front of vehicle.

Screw together and tighten using two

Two screws (8), new

46. Mounting bracket

7/16-inch open-end wrenches.

Iockwashers (9),

(7) and cab

floor (5)

and nuts (10)

4-554