 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-270-20-2
AUXILIARY TRANSMISSION SHIFT CONTROL - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
CLEANING/INSPECTION
Clean as shown in the general maintenance
All parts, except
16.
instructions (page 4-1).
knob (1)
Inspect as shown in the general mainten-
All parts
17.
ance instructions (page 4-1).
INSTALLATION
a. Put rod (3) in vise.
Two nuts (3)
18. Shift rod (2)
b. Screw in as far as possible using 15/16-
inch open-end wrench.
Screw in number of turns noted during re-
Two yokes
19.
moval using pipe wrench.
(4) and (5)
Screw in and tighten using 15/16-inch
Two nuts (2)
20. Shift rod (2)
open-end wrench and pipe wrench.
and two yokes
(4) and (5)
a. Take out of vise.
Shift rod (2)
21. Rod (6)
b. Put in place.
Put in place.
Pin (7)
22. Yoke (5) and rod (6)
Using slip-joint pliers, put in.
New cotter pin (8)
23. Pin (7)
Put in place.
Two brackets (10)
24. Cab floor (9)
With the aid of an assistant, screw in and
Four new Iockwashers
25. Cab floor (9) and
tighten using 7/16-inch socket, 3-inch ex-
(11), washers (12),
two brackets (10)
tension, handle, and 7/16-inch wrench.
screws (13), and
nuts (14)
Put in place.
Shift Iever (15)
26.
Put in place.
Pin (16)
27. Yoke (4) and shift
lever (15)
Using slip-joint pliers, put in.
New cotter pin (17)
28. Pin (16)
Using hammer and 5/16-inch punch, tap
Shaft (18)
29. Two brackets (10)
in place.
and shift lever (15)
4-536
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals