|
|
TM 9-2320-270-20-1
WINCH CONTROL PANEL AUXILIARY THROTTLE SWITCH - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
CAUTION
Make sure ignition switch is off to prevent damage to electrical system.
Do not remove switch lever rubber boot from nut. Removing rubber boot from nut will
ruin it.
NOTE
Tag wires according to general maintenance instructions (page 4-1).
Nut and boot assem-
a. Using 5/8-inch wrench, unscrew and
1. Auxiliary throttle
bly (3) and lock-
pull off.
switch (1) to
washer (4)
b. Get rid of Iockwasher (4).
winch control
c. Inspect boot (3) for cracking or tears.
panel (2)
If cracked or tom, replace assembly.
Auxiliary throttle
2. Winch control
Take out from underneath.
switch (1)
panel (2)
Take off.
3.
ON/OFF ring (5)
Screw (7), lock-
a.
Using screwdriver, unscrew and take
4. Terminal (6)
washer (8), and
off.
wire 167 (9)
b.
Get rid of Iockwasher (8).
Screw (11), lock-
a.
Using screwdriver, unscrew and take
5. Terminal (10)
washer (12), wire
off.
279 (13), and
b.
Get rid of Iockwasher (12).
wire 154A (14)
Screw (16), lock-
a.
Using screwdriver, unscrew and take
6. Terminal (15)
washer (17), and
off.
wire 170 (18)
b.
Get rid of Iockwasher (17).
Screw (20), lock-
a.
Using screwdriver, unscrew and take
7. Terminal (19)
washer (21), and
off.
wire 667 (22)
Get rid of Iockwasher (21).
b.
Auxiliary throttle
Take out.
8. Winch control
switch (1)
panel (2)
4-434
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |