ENGINE SHUTDOWN SOLENOID, LINK, AND LEVER

TM 9-2320-270-20-1

SPEEDOMETER AND TACHOMETER SENDING UNIT - CONTINUED

INSTALLATION CONTINUED

NOTE

FOLLOW-ON MAINTENANCE:

1. Check operation (TM 9-2320-270-10).

2. Close right side of hood (TM 9-2320-270-10).

TASK ENDS HERE

ENGINE SHUTDOWN SOLENOID, LINK, AND LEVER

This task covers:

c. Adjustment (page 4-428)

a. Removal (page 4-423)

b. Installation (page 4-424)

INITIAL SETUP

Materials/Parts Continued

Tools

Lockwasher, solenoid to mounting bracket

Extension, 5-inch, 3/8-inch drive

(four required)

Gage set, thickness

Lockwasher, solenoid bracket to thermostat

Hammer, hand, rubber

housing

Handle, ratchet, 3/8-inch drive

Washer, mounting bracket support to

Joint, universal, 3/8-inch drive

blower housing (two required)

Lifter, battery terminal

Tag, marking (item 18, appendix C)

Pliers, slip-joint

Rule machinist's

Personnel Required

Socket, 7/16-inch, 3/8-inch drive

Socket, 1/2-inch, 3/8-inch drive

One

Socket, 9/16-inch, 3/8-inch drive

Wrench, box, 7/16-inch

Equipment Condition

Wrench, open-end, 1 1/32-inch

Wrench, open-end, 7/16-inch

Right side of hood open and right side

panel removed (TM 9-2320-270-10).

Materials/Parts

Lockwasher, shutdown lever

Lockwasher, solenoid plunger to link

ACTION

REMARKS

ITEM

LOCATION

NOTE

To remove and install solenoid without removing link and lever, do steps 1 thru 10,26

thru 34, and 43 thru 56. To remove and install link and lever without removing solenoid,

do steps 4 thru 6, 11 thru 15, and 35 thru 56.

4-422