 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
REAR-REAR AXLE DIFFERENTIAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
59.
Flanged
Ring gear (2) Lining up holes, place in position.
case (1)
60.
Twelve new
Using riveting fixture and hydraulic press,
rivets (3)
press in.
61.
All parts
Apply rear axle lubricant to all parts,
including inside walls of carrier (4).
62.
Oil scoop (5)
Put in position.
63.
Oil scoop (5)
New lockwasher (6) Screw in, and tighten using 7/16-inch
and screw (7)
socket and ratchet handle with 1/2-
inch drive.
64.
Flanged case (1)
New thrust washer Place in position.
(8) and side
gear (9)
65.
Spider (10)
Four pinion gears
Place in position.
(11) and four new
thrust washers (12)
66.
Flanged case (1)
Spider
Place in position.
differential (13)
67.
Spider
Side gear (14) Place in position.
differential (13)
and new thrust
washer (15)
68.
Flanged case (1)
Bearing case (16) a.
Line up matchmarks.
b.
Put in position.
c.
Turn gears to see if they mesh.
d.
If gears do not move freely, take off
case and reseat them.
69.
Bearing case (16)
Four screws (17)
a.
Space evenly and screw in until
snug.
and nuts (18)
Make sure gears mesh.
b.
If gears mesh properly, go on to
step 70.
c.
If gears do not mesh, take out screws
(17) and nuts (18), take off case (16),
and reseat gears.
d.
Do steps a thru c again.
2-922
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals