 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
POWER DIVIDER LOCKOUT ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
11.
Shift cylinder
Screw (2) Using 9/16-inch socket and ratchet handle
body (1)
with 3/8-inch drive, unscrew and take out.
12.
Shift fork
Shift cylinder body
a.
Take off.
housing (3)
(1) and preformed
b.
Get rid of packing (4).
packing (4)
13.
Shift fork (5)
Setscrew (6) Using 1/4-inch flat-tip screwdriver,
unscrew take out.
14.
Shift fork housing
Dust cap (8) Using 3-lb ball-peen hammer, tap on
(3) and shift fork
shaft (7) until cap'(8) comes out.
shaft (7)
15.
Shift fork
Shift fork shaft (7)
Using 3-lb ball-peen hammer and
1/2-inch
housing (3)
brass driftpin, drive out.
16.
Shift fork (5)
Take out.
17.
Oil seal (9)
a.
Using slide hammer puller, pull out.
b.
Get rid of.
18.
Shift cylinder
Two screens (10)
a.
Using machinist's scribe, pry
out.
body (1)
and filter (11) b.
Get rid of filter (11).
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-46).
WARNING
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow open flame nearby when using solvent.
Failure to observe these precautions could cause serious injury or death.
19.
All metal parts
a.
Clean in drycleaning solvent.
b.
Wipe dry with clean, dry rags.
2-900
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals