|
|
TM 9-2320-269-34-1
INTERAXLE DIFFERENTIAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
42.
Power divider
Interaxle differen-
a.
Put in position so that rear bearing
intermediate
tial assembly (2)
(3) seats into bearing bore.
case (1)
b.
Using plastic-face hammer, tap on
end of shaft (4) to seat.
43.
Interaxle differen-
Housing (5)
a.
Put in place.
tial assembly (2)
b.
Using plastic-face hammer tap to seat.
c.
Measure clearance between front
bearing (6) and housing (5), and
record using thickness gage.
Total end play allowed is 0.000
to 0.005 inch (0.000 to 0.013 mm ).
d.
Take off housing (5).
e.
To determine the thickness of shims
(7) required to obtain the specified
end play, subtract the allowable
end play, 0.000 to 0.005-inch (0.000 to
0.13 mm) from the total end play
recorded in step c above.
f.
Select shim pack with total thickness
within the range found in e above.
Shims are available in thickness
of 0.005 and 0.010 inch (0.13 and
0.25 mm).
44.
Housing (5)
New oil seal (8)
Press on until face of seal (8) is flush
with edge of housing using arbor press.
45.
Shims (7)
Put on.
46.
Interaxle differen-
Housing (5) and
a.
Put on.
tial assembly (2)
new gasket (9)
Make sure shims (7) are centered
on bearing (6).
b.
Using plastic-face hammer, tap to
seat against case (1).
c.
Check end play clearance again, from
step 43c, using thickness gage.
2-884
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |