|
|
TM 9-2320-269-34-1
FORWARD-REAR AXLE DIFFERENTIAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
65.
Continued
k.
If nominal dimension is not correct,
go back to disassembly, to change
shims.
I. If shims were changed, go back to
installation of cage on carrier.
m. Take off pinion setting gage set.
NOTE
If gear was not removed from flanged case, do not do steps 65 and 66.
66.
Flanged case (1)
Ring gear (2)
Place in position.
67.
Twelve new
Put in using riveting fixture and
rivets (3)
hydraulic press capable of delivering 45
to 50 tons (40.8 to 45.3 metric tons).
68.
All parts
Apply rear axle lubricant to all parts,
including inside walls of carrier (4).
69.
Flanged case (1)
New thrust washer
Place in position.
(5) and side
gear (6)
70.
Spider (7)
Four pinion gears
Place in position.
(8) and four new
thrust washers (9)
71.
Flanged case (1)
Spider differen-
Place in position.
tial (10)
72.
Spider differen-
Side gear (11)
Place in position.
tial (10)
and new thrust
washer (12)
73.
Flanged case (1)
Bearing case (13)
Line up matchmarks and put in place.
74.
Bearing case (13)
Eight screws (14)
a.
Screw in until snug.
and nuts (15)
b.
Turn gears to check for free movement.
c.
If gears do not turn freely, take out
screws (14), nuts (15), and case (13)
and reposition gears.
2-864
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |