|
|
TM 9-2320-269-34-1
TANDEM AXLE ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
NOTE
Steps 24 and 25 are saddle cap installation for right side. Repeat steps for left side.
24. Equalizer beam (1)
Two saddle caps (2)
Put in place.
25. Two saddle
Four washers (3)
Using 1 5116-inch socket and torque wrench
caps (2)
and nuts (4)
with 3/4-inch drive, screw on and tighten
to 225 - 275 ft-lb (206 - 373 N m) of
torque.
NOTE
Steps 26 thru 29 are rear-rear axle torque rod installation procedures. Repeat steps for forward-rear axle torque rod.
26. Axle housing
Torque rod (6)
Pull down, and put in position.
bracket (5)
27. Housing bracket
Torque rod
Using ball-peen hammer, drive in.
(5) and torque
stud (7)
rod (6)
28.
Nut (8)
a. Screw on and tighten to 225-250 ft-lb
(306-339 N m) of torque using
1 11/16-inch socket torque wrench
with 3/4-inch drive, and 1 11116-
inch open-end wrench.
TA238512
2-840
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |