|
|
TM 9-2320-269-34-1
STEERING KNUCKLES AND KINGPINS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
44.
Steering
Shims (11) and
Put in to maintain 0.015-inch (0.03
mm)
knuckle (3)
washers (12) as
clearance as outlined in step 43c.
required
45.
Kingpin (13)
a.
Apply grease.
b.
Line up flat with draw key hole.
c.
Using 3-lb ball-peen hammer and 3/4-
inch bronze drift, drive in.
46.
Draw key (14)
Drive in so flat side mates with the
flat on the kingpin using 3-lb ball-peen
hammer and 3/16-inch drive-pin punch.
47.
Draw key (14)
Washer (15) and
Screw on until snug, and tighten to
50-55
nut (16)
ft-lb (68-75 N m) of torque using
9116-inch deep well socket and torque
wrench with 318-inch drive.
TA238505
2-831
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |