 |
|||
|
|
|||
|
Page Title:
INSPECTION/REPLACEMENT - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-269-34-1
TRANSMISSION MODULATOR VALVE ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT - CONTINUED
9.
Cable assembly (1)
a.
Look for kinks or cuts.
b.
Check for binding.
c.
If cable is damaged or binds, replace
modulator valve assembly.
10.
Spring (2)
a.
Look for cracked or broken ends.
b.
Look for damage or loss of tension.
INSTALLATION
11.
Transmission
Cable assembly (1)
Route over transmission to engine
assembly (3)
throttle linkage.
12.
Modulator valve (4)
New packing (5)
Put on.
13.
Transmission
Modulator valve (4)
Push into bore.
assembly (3)
14.
Modulator valve (4)
Retainer (6)
Put into position.
15.
Retainer (6)
Screw (7)
Screw in, and tighten using 1/2-inch
socket and ratchet handle with 3/8-inch
drive.
16.
Clevis (8)
Cable bracket (9)
Put in, and aline hole with elongated slots.
17.
Clevis (8) and
Pin (10) and two
Put in position.
cable bracket (9)
washers (11)
18.
Pin (10)
New cotter pin (12)
Put in, and using angle-nose slip-joint
pliers, spread and bend ends.
19.
Cable (1) and
Cable clamp (14)
Put in position.
mounting plate (13)
20.
Cable clamp (14)
Two screws (15),
Screw on, and tighten using 3/8-inch
new lockwashers
open-end wrench and number two cross-tip
(16), and nuts (17)
screwdriver.
21.
Bracket (18)
Spring (2)
Put on.
2-806
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals