 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
TRANSMISSION HOUSING - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING - CONTINUED
WARNING
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow open flame nearby when
using solvent. Failure to observe these precautions could cause serious injury or death.
Be sure to wear safety goggles or lenses when using compressed air. Compressed air and
particles moved by compressed air can cause damage to your eyes.
14.
All metal parts
a.
Clean in dry-cleaning solvent.
b.
Dry parts with compressed air.
c.
Clean oil passages with a piece of soft
wire and by flushing with drycleaning
solvent.
INSPECTIONIREPLACEMENT/REPAIR
NOTE
For more Information on how to inspect parts, go to General Maintenance Instructions (page 2-46).
Replace damaged or defective parts, as needed.
15.
Transmission
a.
Look for cracks, breaks, and dents.
housing (1)
If cracks and dents are large,
housing should be replace.
b.
Look for nicks, scratches, and burrs
in bores or on mating surfaces.
c.
Remove defects with crocus cloth.
ASSEMBLY
16.
Transmission
Valve guide tube (2)
Using 3/8-inch brass driftpin and ball-
housing (1)
peen hammer, tap in 0.56 - 0.60 inch
(1.42 - 1.52 mm) below adapter mounting
surface.
17.
Spring (3), lube
Put in position.
valve (4), new pack-
ing (5), new gasket
(6), and adapter lube
valve tube (7)
2-786
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals