 |
|||
|
|
|||
|
Page Title:
INSPECTION/REPLACEMENT/REPAIR - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-269-34-1
REAR COVER AND OUTPUT SHAFT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT/REPAIR - CONTINUED
26.
Rear cover
a.
Look for nicks, burrs, and scratches on
assembly (1)mounting surface.
b.
Remove nicks, burrs, and scratches
with crocus cloth.
c.
If nicks and scratches are deep and
could affect sealing, replace the part.
ASSEMBLY
27.
Rear cover
New plug (2)
Using 5/16-inch socket-head screw key,
assembly (1)
screw in and tighten.
28.
Two plugs (3)
Using 7/16-inch socket and ratchet handle
with 3/8-inch drive, screw in.
CAUTION
If the governor support pin is not positioned correctly, governor, cover driven gear can
be damaged.
29.
New governor
a.
Put in position.
support pin (4)
b.
Using 3/16-inch brass driftpin and
ball-peen hammer, tap in to dimension
shown.
30.
New drain tube (5)
Tap in using ball-peen hammer.
31.
Snapring (6)
Using 3/8-inch flat-tip screwdriver, put
in.
32
Output shaft ball
Using output shaft bearing installer, seat
bearing (7)
against snapring.
33.
Snapring (8)
Using 3/8-inch flat-tip screwdriver, put
in so leveled side faces rear.
34
.New output shaft
a. Apply non-hardening sealant to outer
seal (9)
rim.
b. Put on output shaft oil seal installer,
spring side away from installer.
c. Using ball-peen hammer, drive into
place.
Seal should be 1.03 - 1.07 inches
(2.62 - 2.72 mm) below rear face of
seal bore.
2-776
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals