|
|
TM 9-2320-269-34-1
REAR COVER AND OUTPUT SHAFT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
NOTE
Do not perform steps 14 thru 18 unless part replacement is necessary.
14.
Rear cover
Output shaft bear-
a.
Place rear cover (1) on workbench,
assembly (1)
ing dust shield (2)
front side down.
b.
Using seal and dust shield remover,
take out.
c.
Get rid of.
15.
Output shaft bear-
a.
Using seal and dust shield remover,
ing seal (3)
take out.
b.
Get rid of.
16.
Snapring (4)
Using 3/8-inch flat-tip screwdriver, take
out.
17.
Output shaft ball
Take out.
bearing (5)
18.
Snapring (6)
Using 3/8-inch flat-tip screwdriver, take
out.
19.
Two plugs (7)
Using 7/16-inch socket and ratchet handle
with 3/8-inch drive, unscrew and take out.
20.
Drain tube (8)
a.
Using slip-joint pliers, pull out.
b.
Get rid of.
21.
Governor support
Using 3/16-inch brass driftpin and ball-
pin (9)
peen hammer, drive out.
22.
Plug (10)
Using 5/16-inch socket-head screw key,
unscrew and take out.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions
2-774
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |