THIRD RANGE CLUTCH INSTALLATION

TM 9-2320-269-34-1

TRANSMISSION SUBASSEMBLIES - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

THIRD RANGE CLUTCH INSTALLATION - CONTINUED

108.

Transmission

Third clutch backing

Put in.

housing (1)

plate (2)

109.

Internal

a. Using 3/8-inch flat-tip screwdriver,

snapring (3)

put in.

b. Using a snapring gage, check clearance

between snapring and backing plate.

This clearance should be 0.045 -

0.109 inch (1.14 - 2.77 mm). If

clearance Is correct, small end of

gage will fit, but large end will not.

c. If clearance is not correct, measure

total clutch pack thickness.

d. Replace clutch plates with thicker or

thinner plates to get correct clearance.

e. If necessary, replace backing plate (2)

with a thicker or thinner plate.

FORWARD RANGE CLUTCH INSTALLATION

NOTE

If removed, make sure bearing race has been installed on top hub of fourth clutch housing.

110.

Fourth clutch supply

Fourth clutch

a. Aline the internal-splined plates

port (4)

plates (5)

of fourth clutch.

TA238417

2-682