|
|
TM 9-2320-269-34-1
TRANSMISSION SUBASSEMBLIES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
FIRST RANGE CLUTCH INSTALLATION - CONTINUED
93.
Transmission
First clutch
Put in, flat side first.
housing (1)
backing plate (2)
94.
Internal
a. Using 3/8-inch flat-tip screwdriver,
snapring (3)
put in.
b. Using first clutch gage, check clear-
ance between snapring (3) and backing
plate (2).
Clearance should be between 0.063-
0.136-Inch (1.60-3.45 mm). If
clearance Is correct, small end of
gage will fit but large end will not.
c. If clearance is not correct, measure
the total clutch pack thickness.
Replace clutch plates with thicker or
thinner plates to get correct clear-
ance. If necessary, replace backing
plate with a thicker or thinner plate.
GEAR UNIT INSTALLATION
95.
Gear unit (4)
Sun gear thrust
a. Grease with oil soluble grease.
washer (5)
b. Put on.
TA238413
2-678
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |