ADAPTER HOUSING REMOVAL

TM 9-2320-269-34-1

TRANSMISSION SUBASSEMBLIES - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

ADAPTER HOUSING REMOVAL

55.

Transmission

Adapter housing (2)

a. Lift off.

housing (1)

and gasket (3)

It may be necessary to tap housing

with plastic-face hammer to loosen.

b. Get rid of gasket (3).

SNAPRING CLEARANCE CHECK

CAUTION

Make sure all transmission subassemblies have been thoroughly cleaned, in their respective

maintenance procedures. Even small amounts of dust or dirt on parts will cause transmission

damage.

NOTE

Soak all internal splined clutch plates in transmission oil for at least 2 minutes before assembling.

The second clutch backing plate is available in two thicknesses: 0.476 0.486 inch(12.09 12.34 mm)

and 0.450 0.460-inch (11.43 11.68 mm). Choose one of these plates for a trial measurement, as

described in the following steps. If measurement is not within tolerance, the other size backing

plate may have to be used.

56.

Second clutch

With the transmission positioned with con-

backing plate (4)

verter end up, put into place.

TA238401

2-666