 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
TRANSMISSION ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
51.
Shift shaft (1)
Shift lever (2)
Put on.
52.
Shift lever (2)
Nut (3)
Screw on, and tighten using 9/16-inch soc-
ket and ratchet handle with 112-inch drive.
53.
Transmission (4)
Cable clamp (5),
Place in position.
bar (6), and
cable (7)
54.
Cable clamp (5)
Two screws (8),
Screw in, and tighten using number two
new lockwashers
cross-tip screwdriver and 3/8-inch
(9), and nuts (10)
open-end wrench.
55.
Governor cover (11)
Screw (12)
Using 1/2-inch socket and ratchet handle
with 1/2-inch drive, take out.
56.
Cable clamp (13)
Put in position.
57.
Screw (12)
a. Screw in until snug using 1/2-inch
socket and ratchet handle with
1/2-inch drive.
b. Tighten to 15-20 ft-lb (20-27 N m) of
torque using 1/2-inch socket and
torque wrench with 1/2-inch drive.
58.
Oil temperature
Two screws (15)
a. Position wires (16) and (17) as tagged.
sending unit (14)
and wires (16)
b. Screw in, and tighten using 114-inch
and (17)
flat-tip screwdriver.
59.
Neutral start
Four connectors
Connect wires as tagged.
switch wires (18)
(19) and (20)
60.
Transmission (4)
Bracket (21)
Put in position.
61.
Bracket (21)
Screw (22) and new
Screw in, and tighten using 9/16-inch
lockwasher (23)
socket and ratchet handle with 1/2-inch
drive.
62.
Cable clamp (24),
a. Place wires (18) between bracket (21)
screw (25), and
and cable clamp (12).
nut (26)
b. Screw on, and tighten using two 7/16-
inch open-end wrenches.
63.
Speedometer cable
Nut (28) and
Screw on, and tighten using two 1-inch
adapter (27)
cable (29)
open-end wrenches.
2-648
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals