|
|
TM 9-2320-269-34-1
STARTING MOTOR - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
142.
End plate (1)
New packing (2)
a.
Apply oil-soluble grease.
b.
Put in place.
143.
Armature (3)
End plate (1) Put on.
144.
End plate (1)
Eight brushes (4)
Using 3/16-inch flat-tip screwdriver,
pry up springs (5) and put in brushes
in order marked on tags, with groove
toward screw holes.
145.
Six brushes (4)
Six screws (6)
a.
Remove tags.
b.
Screw in, and tighten using 1/4-inch
flat-tip screwdriver.
Do not put screws in each rear
holes of the two Insulated brush
holders.
146.
Field frame (7)
Assembled end
Noting scribe marks, slide in
armature (3)
plate (1) and
engaging splines in drive clutch (8).
armature (3)
Do not allow end plate to slip off
of armature.
147.
Two insulated brush
Two brush leads (10) Aline holes in brush holder (9).
holders (9)
and two field
leads (11)
148.
Two screws (12)
Screw in, and tighten using 114-inch
flat-tip screwdriver.
149.
End plate (1)
Four new lockwashers
a.
Be sure armature
is seated in end
(13) and screws (14)
plate bushing and drive clutch splines.
b.
Screw in, and tighten using 6-point
7116-inch socket and ratchet handle
with 3/8-inch drive.
150.
Two brush plugs (15)
Two new gaskets (16) Put on.
2-456
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |