|
|
TM 9-2320-269-34-1
STARTING MOTOR - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
128.
Lever housing (1)
New packing (2)
Put on.
129.
Field frame (3)
Lever housing (1)
Line up scribe marks and put in
position.
130.
Lever housing (1)
Five new lockwashers a.
Screw In using 7116-inch
box-end
(4) and screws (5)
wrench.
b.
Tighten to 156 in-lb (18 N m) of
torque, using 7/16-inch socket and
torque handle with 3/8-inch drive.
131.
Solenoid (6)
Boot (7)
Put in place.
132.
Armature (8)
Thrustwasher (9)
Put in place on commutator end.
133.
Thrustwasher (10)
Put in place on drive clutch end.
NOTE
If new brushes are to be installed, do steps 134 thru 141. If old brushes are being installed,
continue task at step 142.
134.
Armature (8)
a.
Cover commutator (11) with one layer of
two sided pressure sensitive tape.
b.
Cover tape with one layer of sandpaper
overlapped slightly at ends.
135.
Armature (8)
End plate (12)
Put on.
136.
End plate (12)
Eight brushes (13)
Using 3/16-inch flat-tip screwdriver,
pry up springs and put in brushes (13)
with groove toward screw holes.
137
.
Armature (8)
Rotate slowly, several revolutions so
brushes (13) are sanded to contour.
138.
Armature (8)
End plate (12)
Take off.
139.
End plate (12)
Eight brushes (13)
Tag brushes and screw holes in
brush
holders (14), and take out.
2-454
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |