|
|
TM 9-2320-269-34-1
WATER PUMP - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
16.
Bushing (1)
New water pump seal
a.
Note marks, either three dots or a
seat (2)
groove.
b.
Put in.
17.
Impeller (3)
Bushing (1) and
Put in.
water pump seal
seat (2)
18.
Water pum p
New water pump
Using arbor press, press in.
housing (4)
seal (5)
19.
Shaft (6) with bear-
Using arbor press, press in until bearing
ing assembly (7)
(7) bottoms.
20.
Snapring (8)
Using snapring pliers, put in.
21.
Shaft (6) with
Pulley hub (9)
Using arbor press, press on.
bearing assembly (7)
22.
Impeller (3) with
Using 0.060-inch (1.47-mm) shim stop
bushing (1) and
and arbor press, press in.
water pump seal
seat (2)
23.
Water pump body (10)
Water pump
Put in.
housing (4)
24.
Water pu mp
Two screws (11)
a.
Screw in, and tighten using 3/16-inch
housing (4)
socket-head screw key.
b.
Using thickness gage, measure and re-
cord clearance between housing (4)
and body (10).
c.
Using 3/16-inch socket-head screw
key, unscrew and take out.
25.
Water pump body (10)
Water pump
Take out.
housing (4)
26.
Shaft (6)
Impeller (3)
a.
Add 0.010 to 0.020 inch (0.254 to
0.508 mm) running clearance to re-
corded clearance from step 24.
b.
Subtract combined clearanc es from the
0.060-inch (1.47-mm) shim stop thick-
ness, and record the difference.
2-404
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |