 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
GOVERNOR
This task covers:
a. Disassembly (page 2-335)
c. Inspection/Replacement (page 2-346)
b. Cleaning (page 2-346)
d. Assembly/Adjustment (page 2-346)
INITIAL SETUP
Tools - Continued
Tools
Wrench, open-end, 10-mm (two required)
Wrench, pliers
Bit, screwdriver, flat-tip,
Wrench, torque, 1/2-inch drive,
1/2-inch drive, 318-inch
0-175 ft-lb capacity
Bit, screwdriver, flat-tip,
1/2-inch drive, 15/16-inch
Materials/Parts
Brush, wire
Bushing, trial spacer (two required)
Bolt, governor, with two nuts, washers,
Extension, 3/8-inch drive, 3-inch
and lockwashers
Extension, 112-inch drive, 3-inch
Compound, sealant, non-hardening (item 13,
Face, inserted hammer, hard-plastic
(appendix B)
Fixture, holding, fuel injection pump
Crocus cloth (item 7, appendix B)
Hammer, ball-peen, machinist's
Fuel, diesel, No. 2 (item 17, appendix B)
Handle, hinged, 112-inch drive
Gasket, control-rack stop
Handle, ratchet, 3/8-inch drive
Gasket, governor cover (two required)
Holder, inserted hammer-face
Gasket, governor housing (two required)
Key, socket-head screw, 10-mm
Gasket, governor housing plug
Knife, putty
Gasket, governor plug (two required)
Micrometer, depth
Lockplates, governor bushing (two required)
Pan, drain
Lockwasher, bracket bolt
Pliers, diagonal cutting
Lockwasher, bracket-to-pump (two
Pliers, round-nose, long
required)
Pliers, slip-joint
Lockwasher, flange (two required)
Pliers, soft jaw
Lockwasher, governor cam bracket
Press, arbor, hand-operated
Oil, engine (item 32, appendix B)
Puller, flyweight
Packing, governor (two required)
Punch, straight, blunt-end, 5116-inch
Pin, cotter (four required)
Remover tool, flyweight damper
Rags, wiping (item 42, appendix B)
Screwdriver, flat-tip, 1/8-inch
Seal, oil, governor cover
Screwdriver, flat-tip, 114-inch
Seal, securing bar
Screwdriver, flat-tip, 5/16-inch
Tag, marking (item 50, appendix B)
Screwdriver, flat-tip, 318-inch
Washer, retaining, governor bolt
Socket, 318-inch drive, 9116-inch
Wire, sealing (item 58, appendix B)
Socket, 318-inch drive, 6-mm
Socket, 3/8-inch drive, 8-mm
Personnel Required
Socket, 318-inch drive, 10-mm
Two
Socket, 3/8-inch drive, 12-mm
Socket, 3/8-inch drive, 21-mm
Equipment Condition
Vise, machinist's
Fuel injection pump removed (page 2-278).
Wrench, drive-flange holding
Wrench, governor-spring adjusting
Wrench, holding, camshaft
Wrench, open-end, 8-mm (two required)
2-334
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals